Fujiya automatic liquid dispenser with time control to push the liquid pneumaticall

1) automatic liquid dispenser
2) controlled by timer
3) regulated the air pressure
Fujiya automatic liquid dispenser with time controller

Description
Fujiya automatic liquid dispenser with time control, to push the liquid pneumatically, controlled by timer, to be sure the same dispensing drops and dispensing cycle time, regulated the air pressure with suitable tip at your equipments of the different liquids as glues, greases, solder pastes, Applied for 10 types of steel tips and 5 types of plastic tips for various customers’ needs.
TeCHENICAL DATA
Timer
Programmable:0.01~1S; 0.1~10S
0.2~20S; 0.3~30S;

Cycle Initiation
Maintained or Momentary

Repeat Tolerance
±0.5%
Size
235*225*63 mm

Weight
2.20kg
Voltage Input
220-240V 50Hz AC
Internal Voltage
24V DC
Minimum Deposit
0.01ml
Air Input
2.5 ~ 7bar (35~100 psi)
Air Output
0.1~5.5bar (1-78 psi)
DOTTING RANGE REGULATED
Under the “auto” mode, full clockwise turn of timer knob, to step the foot switch, as:
Drip switch is on at 1: dispensing time > 1s
Drip switch is on at 1,2: dispensing time> 10s
Drip switch is on at 1,2: and 3: dispensing time > 20s
Drip switch is on at full grades: dispensing time>30s
Customer can adjust according to time-being requirements.
Internal air pressure regulated
On the air pressure regulated knob, regulated internal air pressure, on the air pressure gauge, general used between 0.1-2.7 bar (1-40 psi)
Vacuum control regulated
On the vacuum control knob, regulated the ending dot in the air reflation, avoid dotting connected with others.

Setup
Connect the 7 bar dry and filtered air supply to the units air input plug.
Put the material and parts in barrel properly.
Insert the power plug, foot switch plug and hose plug into the concerned sockets.
Operation
Turn the unit on and indicator at “on” position light up.
Pull the air pressure regulator knod outward and turn clockwise until the desired air pressure is indicated.
Maintenance
To assure trouble free operation, the following points should be followed:
Make certain air supply is clean and dry.
Make certain AC outlet is grounded and proper voltage rating.
Avoid turning barrels upside down or laying barrel, so that material may run through air Line to internal components.
Do not allow barrel assemblies to contact hot or sharp objects.
Avoid connecting liquid dispenser to air supply exceeding 7 bar (100psi)
Avoid exposing liquid dispenser to excessive moisture of solvent situation.