Epoxy adhesive(2013A/B)

2013 Epoxy adhesive is a low viscosity epoxy especially developed for production of
Articles and mould cast.The hardener is low

Epoxy Resin 2013A/B
DESCRIPTION:
2013 Epoxy adhesive is a low viscosity epoxy especially developed for production of
Articles and mould cast.The hardener is low contractility, high physical dimension stable. Compatibility with fibers and caulking material. A wide range use for mould cast, manufacture composite material and encapsulation of transformers and coils for the electronic and electrical industries
SPECIFICATION:
PARTS
Appearance
Viscosity at 25 0c
(mPa s)
Density at 25 0c
g/cm3
Shelf life
2013A
Buff, Transparent.
Liquid
3500-3800
1.53
12 months
2013B
Colorlessness
Transparent.
Liquid
100-150
0.92
12 months
Ratio for weight:
AB=100:25
Curing Time:
6-8 hours at 25
2 hours at 35
Complete Data sheet:
Compressive strength: 70-75 N/mm2
Tensile strength: 38.4 Mpa
Shore hardness: 80-85 ShoreD
Flexural Strength: 55-68
N/mm2
Distortion Temperature: 80
Impact toughness: 0.62 KJ/m2

PRECAUTIONS:
High atmospheric humidity or drops in temperature around dew point may result in condensation on the uncured film causing changes in the film surface as a result of hydration. This effect may cause loss of intercoat adhesion. In these conditions good adhesion may be obtained
by re-roughening the surface.

IMPORTANT NOTE:
The specification listed above is given to the best of our knowledge, however, it is given without any warranty expressed or implied. The specification is subject to change without notice. Consult QUALITY CONTROL REPORT available for each Batch for actual results.